
Application Guide
- Remove old skates with the plastic pry tool.
- Clean any remaining adhesive with your thumb, then finish with an alcohol wipe. Very stubborn adhesive can be removed with the sandpaper.
- Position the skates near the edges.
- Clean the skates with the alcohol pad.
- Press firmly, wait a few seconds – ready to use.

Adhesive Replacement Guide
- Peel off the old adhesive from the skates.
- Clean the underside with alcohol, remove any residue and let them dry.
- Apply a fresh adhesive from the adhesive sheet to the skate.
- Reapply skates.

Maintenance
- Clean the skates regularly with the provided microfiber cloth to remove any possible oil or dust
- Keep your mousepad clean by washing it regularly using soap and warm water

Setting it up
Our sapphire skates are slightly thicker than normal PTFE dots to prevent mousepad scratching while still staying in the usual LOD range. Some gaming mice might need adjustment in the LOD settings for proper tracking. A higher skate leads to a longer distance between sensor and mousepad which results in a slightly lower DPI. We recommend raising the DPI by 10 points.
Note: For cloth mousepads only.