Instructions

SORA V2 BASED PRE-BUILTS

TURNING ON THE MOUSE

You can turn on the mouse by sliding the small white pin towards the front of the mouse.

The dongle LED should light up.

If it doesn't, either the battery is empty or the mouse is not paired.

CONFIGURE YOUR MOUSE

To change DPI, change the LOD and pair a new dongle here.

PAIRING WITH A NEW DONGLE

1k dongle
1. Turn off the power of the mouse, unplug the receiver and place it closer to the mouse. 2. Turn on the mouse. 3. Press the left, middle and right buttons for ten seconds at the same time. 4. Plug the receiver into the charging cable.

8k dongle
1. Download "NinjaForce Updater" from official page [https://drive.google.com/file/d/1PVRF0Pn75qOS4Hg06KYsyeR3fUw0tEXo/view]
2. Update 8K dongle and mouse firmware
3. Connect mouse to NinjaForce [https://ninjaforce.co/] web software in wired mode
4. Pair mouse with 8K dongle in "Settings"

Note: connect the 8K receiver with the included 8K cable

CHARGE

Regularly charge the mouse using the USB-C cable. Check for the battery percentage in Synpase. Smaller batteries like the 150mAh may show a percentage of for example 60% when they are full.